Asus H310T-A R2.0 Manual page 10

Internal DC power connector (4-pin ATX19V)
This connector is for an ATX power supply. The plug from the power supply is
designed to fit this connector in only one orientation. Find the proper orientation
and push down firmly until the connector completely fits.
This connector supports 12V and 19V by models. Refer to the specification sheet of the
model for details.
CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside
the system may damage the motherboard components. These are not jumpers! Do not
place jumper caps on the fan connectors! The CPU_FAN connector supports a CPU fan
of maximum 0.5A (6 W) fan power.
USB 3.1 Gen 1 (up to 5Gb/s) connector (20-1 pin U31G1_12)
Connect a USB 3.1 Gen 1 module to this connector for additional USB 3.1
Gen 1 front or rear panel ports. This connector complies with USB 3.1 Gen 1
specifications and provides faster data transfer speeds of up to 5 Gbps, faster
charging time for USB-chargeable devices, optimized power efficiency, and
backward compatibility with USB 2.0.
Intel H310 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~2)
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
DDR4 DIMM slots
Install 2 GB, 4 GB, 8 GB, and 16 GB unbuffered non-ECC DDR4 DIMMs into these
DIMM sockets.
For more details, refer to System memory.
SATA power connector (15-pin SATA_PWRCON)
This connector is for the SATA power cable. The power
cable plug is designed to fit this connector in only one
orientation. Find the proper orientation and push down
firmly until the connector completely fit. To provide power to
your SATA device, connect the SATA power cable to this
connector.
Speaker connector (4-pin SPEAKER)
The 4-pin connector is for the chassis-mounted system warning speaker. The
speaker allows you to hear system beeps and warnings.
System panel connector (10-1 pin F_PANEL)
This connector supports several chassis-mounted functions.
1-2
SATA_PWRCON
Chapter 1: Product introduction
PIN 1