Using An Accessory Rf Modulator; Step 5: Connecting Fm/Mw Antennas - Philips MCD708/05 User Manual

Using an accessory RF modulator

IMPORTANT!
– If your TV only has a single Antenna In
jack (labeled as 75 ohm or RF In), you
will need an RF modulator in order to
view DVD playback on the TV. Visit your
electronics retailer or contact Philips for
details on RF modulator availability and
operations.
ANT IN
1
Use the composite video cable (yellow) to
connect the VIDEO OUT jack on the DVD
system to the video input jack on the RF
modulator.
2
Use an RF coaxial cable (not supplied) to
connect the ANTENNA OUT or TO TV jack on
the RF modulator to the Antenna IN jack on
your TV.
3
Connect the Antenna or Cable TV service signal
to the ANTENNA IN or RF IN jack on the RF
modulator. (It may have been connected to your
TV previously. Disconnect it from the TV.)
RF coaxial cable to TV
2
INT IN TO TV AUDIO IN
VIDEO
IN
R L
CH3 CH4
3
1
Step 5: Connecting FM/MW
antennas
fix the claw into
the slot
FM
2
antenna
SUB WOOFER
1
Connect the supplied MW loop antenna to the
MW jack. Place the MW loop antenna on a shelf
or attach it to a stand or wall.
2
Connect the supplied FM antenna to the FM (75
Ω) jack. Extend the FM antenna and fix its end to
the wall.
For better FM stereo reception, connect an
external FM antenna (not supplied).
Note:
– Adjust the position of the antennas for optimal
reception.
– Place the antennas as far as possible from your
TV, VCR or other radiation sources to prevent
interference.
Connections
MW
1
antenna
13