Troubleshooting - Philips DCM292/12 User Manual

9 Troubleshooting

Warning
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/welcome). When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
No power
Ensure that the AC power plug of the
unit is connected properly.
Ensure that there is power at the AC
outlet.
To save power, the unit switches to Eco
Standby mode automatically after 15
minutes in standby mode.
No sound
Adjust the volume.
No response from the unit
Disconnect and reconnect the AC power
plug, then turn on the unit again.
No disc detected
Insert a disc.
Check if the disc is inserted with the print
side facing inward.
Wait until the moisture condensation at
the lens has cleared.
Replace or clean the disc.
22 EN
Remote control does not work
select the correct source with the remote
control instead of the main unit.
Reduce the distance between the remote
control and the unit.
Insert the battery with its polarities (+/–
signs) aligned as indicated.
Replace the battery.
Aim the remote control directly at the
sensor on the front of the unit.
device has exceeded a certain limit. This
phenomenon is not a malfunction.
supported.
USB device not supported
The USB device is incompatible with the
unit. Try another one.
Poor radio reception
Increase the distance between the unit
and your TV or VCR.
Fully extend and adjust the FM antenna.
Clock/timer setting erased
Power has been interrupted or the power
cord has been disconnected.
Reset the clock/timer.
Timer does not work
Set the clock correctly.
Switch on the timer.