Video and audio over ethernet standalone transmitter,
video and audio over ethernet pc card transmitter,
video and audio over ethernet receiver (29 pages)
Page 1
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500) SUPPORT FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746 INFORMATION Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018 Web site: www.blackbox.com • E-mail: info@blackbox.com...
Page 3
FCC/IC RFI STATEMENTS, EU DECLARATION OF CONFORMITY FEDERAL COMMUNICATIONS COMMISSION FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio-frequency energy, and if not installed and used properly, INDUSTRY CANADA that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication. RADIO FREQUENCY INTERFERENCE STATEMENTS It has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable protection against...
For example, when daisy chaining over 600 ft, an AC1062A-R2 can be daisy chained to an AC1063A-R2 over 600 ft. up to 1200 ft. A maximum of 12 units may be daisy chained.
CAT5 MULTI VGA SYSTEM WARNING This equipment is not intended for, nor does it support, distribution through an Ethernet network. Do not connect these devices to any sort of networking or telecommunications equipment! 2.2 Package Contents You should have received the following when ordering a CAT5 Multi VGA System receiver: •...
CHAPTER 3: Setup and Installation 3. Setup and Installation 3.1 Making the Connections 3.1.1 C ONNECTIONS AND ETUP IN ENERAL This section contains figures showing connections with the specific CAT5 Multi VGA System models. In general, however, the connection and setup procedure at both transmitter and receiver ends is as follows (see sections 3.1.2, 3.1.3 for typical connections and section 3.3 for typical applications): At the transmitter end:...
Figure 3-2. Receiver connections on the AC1062A-R2 and AC1062-DA-R2. Note that the AC1062-R2 cannot be used in the middle of a daisy chain. Figure 3-3. Receiver connections on the AC1063A-R2 and AC1063-DA-R2. Note that the AC1063-R2 cannot be used in the middle of a daisy chain.
Page 12
CAT5 MULTI VGA SYSTEM 3.1.3 R ECEIVER ONNECTIONS: Figure 3-4. Receiver connections on the AC1064A-R2 and AC1064-DA-R2. Note that the AC1064-R2 cannot be used in the middle of a daisy chain.
The brightness in the white area should be the same as the white area above and below the black box. The Cable Length LEDs will turn on for indicated cable distances (AC1064A-xx). Starting from zero feet to 600/1200/2000 may take some time.
CAT5 MULTI VGA SYSTEM 3.2.3 Skew Compensation Settings The AC1062A-xx, AC1063A-xx, AC1064A-xx receivers are available with an optional skew compensation module to adjust for signal timing differences due to differing pair lengths within the CAT5 cable. Using the delay signals, skew may be compensated from 2 to 65 nanoseconds in 2 nanosecond increments on each individual color pair.
CHAPTER 3: Setup and Installation 3.3 T YPICAL PPLICATIONS Figures 3-9 to 3-11 show typical applications: Figure 3-7. Point to Point Application Figure 3-8. Daisy Chain Distribution...
CAT5 MULTI VGA SYSTEM 4. Troubleshooting 4.1. Common Problems In most cases, nearly every issue with the CAT5 Multi VGA System can be resolved by checking the CAT5 termination and making sure that it’s pinned to the TIA/EIA 568B wiring specification. However, there may be other problems that cause the system to not perform as it’s designed.
It is possible to daisy chain out of a short range receiver into a longer range receiver. For example, over 600 ft an AC1062A-R2 can be daisy chained into on AC1063A-R2 which allows for daisy chaining to 1200 ft.
The following diagrams show the switch location and settings for the AC1060A transmitter assembly. Note: Switch settings other than shown below may result in unpredictable performance and are not supported by Black Box. DC restore option (AC1060A-R2 only): Mode 1 Enable: Switch position B, C ON (UP)
APPENDIX C: Receiver Video Modes Appendix C. Receiver Video Modes The Cat5 Multi VGA System receivers feature the ability to display five component RGBHV computer video as well as RGBS, RGsB and full component RGB video. The transmitter units need no configuration changes. The AC1062A-xx, AC1063A-xx, AC1064A-xx feature an auto-sense mode to determine RGBHV or not is in use.
CAT5 MULTI VGA SYSTEM Appendix D. Rackmounting Units The Cat5 Multi VGA System components can be rack mounted in 19” wide cabinets. Below is a table showing the various rackmount kits available . Figure D-1 shows a typical rackmount application. Transmitters: Rackmount PN Description AC1060A...