Page 1
Base Screws (M4x14) x 4 Warranty Card x 1 Display Remote Control (AAA batteries included) x 1 User Guide x 1 (Complete manual available online at sceptre.com) Recycling Information Dispose unwanted electronics and batteries through an approved recycler. For TVs please visit the web at http://www.earth911.com/recycling-guide/how-to-recycle-large-electronics/...
Ready to Watch Some TV? (Optional) Make sure your power cable is connected and the standby red light in the front of the HDTV is lit up. Check all your connection cables off the side or the back of your HDTV and also your AV devices.
If You've Connected Cable or Satellite Set-to p Boxes to the HDTV ... Source Select YPbPr HDMI1/MHL HDMl2 HDMl3 Media ® Press the button on the side of the HD Display or the SOURCE button on the remote control and you will see the picture above. Use •...
Page 6
Customer Service Email: SceptreCS@Sceptre.com T EL: 1(800) 788-2878 SCEPTRE Remote Control Please insert two AAA batteries into the remote control. Make sure that you match the(+) and(-) symbols on the batteries with the(+) and (-) symbols inside the battery compartment. Afterwards, re-attach the battery cover.
Page 7
This remote control follows SONY's universal remote code. To find the actual code you need to consult your cable or satellite tech support. FRD Series Page 17...
GENERAL FUNCTION BUTTONS POWER - Turns the display on or off. INFO - Shows the display info. NUMBER BUTTONS (0-9) Press 0-9 to select a TV channel directly when you are watching TV. The channel will change after 2 seconds. For switching DVD chapters over 100 the O button acts as the 100 button, so press the O button twice to get that chapter.
The following buttons are functions designed to work with the optional, Sceptre Sound Bar. 40. POWER – This button turns on the sound bar. 41. SOURCE – This button selects the sound bar’s source. 42. MODE – This button selects the sound bar’s sound modes.
FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: This device may not cause harmful interference This device must accept any interference received, including interference that may cause undesired operation. Please Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
SCEPTRE is a trademark or registered trademark of Sceptre Group. Sceptre, Inc. shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from furnishing this material, or the performance or use of this product.