•
Connect the AC power cord to
•
the DC-IN socket on the back of the
main speaker.
•
the wall power socket.
Turn DS6800W on
1
Press
to turn the unit on.
2
Wait for successful boot-up of the unit.
» The boot-up takes about 35 seconds.
» During boot-up, the Wi-Fi SETUP
indicator on the back of the main
speaker blinks green quickly.
» After boot-up, if no Wi-Fi connection
has been set up for DS6800W, the
Wi-Fi SETUP indicator starts to blink
green slowly.
•
To turn the unit off, press
8
EN
Prepare the remote control
For À rst-time use:
1
To replace the remote control battery:
1
2
3
again.
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or À re. Never discard batteries in À re.
•
Perchlorate Material - special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
Remove the protective tab to activate the
remote control battery.
Open the battery compartment.
Insert one CR2032 battery with correct
polarity (+/-) as indicated.
Close the battery compartment.
Note
•
Before pressing any function button on the remote
control, À rst select the correct source with the remote
control instead of the main unit.
•
If you are not going to use the remote control for a
long time, remove the battery.