Black Box Desktop Telephony HS117A Manual
Black Box Desktop Telephony HS117A Manual

Black Box Desktop Telephony HS117A Manual

Combo headset
Hide thumbs Also See for Desktop Telephony HS117A:

Advertisement

Quick Links

Combo
Headset
HS117A

Advertisement

Table of Contents
loading

Summary of Contents for Black Box Desktop Telephony HS117A

  • Page 1 Combo Headset HS117A...
  • Page 2 FCC INFORMATION FEDERAL COMMUNICATIONS COMMISSION INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication.
  • Page 3 COMBO HEADSET FCC REQUIREMENTS FOR TELEPHONE-LINE EQUIPMENT 1. The Federal Communications Commission (FCC) has established rules which permit this device to be directly connected to the telephone network with standardized jacks. This equipment should not be used on party lines or coin lines. 2.
  • Page 4 CDC STATEMENT Items (b) and (d) can be found on the unit’s FCC label. The ringer equivalence number (REN) is used to determine how many devices can be connected to your telephone line. In most areas, the sum of the RENs of all devices on any one line should not exceed five (5.0).
  • Page 5 COMBO HEADSET CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. The LOAD NUMBER (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which is used by the device, to prevent overloading.
  • Page 6 NOM STATEMENT 7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado por el fabricante. 8. Servicio—El usuario no debe intentar dar servicio al equipo eléctrico más allá a lo descrito en las instrucciones de operación.
  • Page 7 COMBO HEADSET 17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre la cubierta u orificios de ventilación. 18. Servicio por personal calificado deberá ser provisto cuando: A: El cable de poder o el contacto ha sido dañado; u B: Objectos han caído o líquido ha sido derramado dentro del aparato;...
  • Page 8 TRADEMARKS USED IN THIS MANUAL TRADEMARKS USED IN THIS MANUAL is a registered trademark of Underwriters Laboratories, Inc. ® Any other trademarks mentioned in this manual are acknowledged to be the property of the trademark owners.
  • Page 9: Table Of Contents

    5.2 Calling Black Box ........
  • Page 10: Specifications

    CHAPTER 1: Specifications 1. Specifications Current Consumption—10 to Weight—2.4 oz. (68 g) 120 mA Receive: Operating Voltage—3 V Speaker—Dynamic General: Input Impedance—300 ohms Compliance—UL ® 1459, FCC Frequency Response—300 to Part 68 3000 Hz Operating Temperature—32 Automatic Gain Control to 122°F (0 to 50°C) (AGC)—30 dB Polarity—Non-polar Volume Control Range—...
  • Page 11: Introduction

    COMBO HEADSET 2. Introduction C. Receiver Housing 1. Volume Control 2.1 Description 2. Mute Button The Combo Headset with built-in amplifier and headset/handset 3. Ear Cushion Mounted on switch features: Earplate • Universal telephone D. Flexible Microphone Boom interface for compatibility with most domestically E.
  • Page 12: Installation

    CHAPTER 3: Installation 3. Installation port for a headset handset to the handset port connection, disconnect the on the switch. handset cord from the 3.1 Connecting to Your Telephone c. Connect the handset port telephone. Insert the 1. First, connect the headset on your telephone to the modular plug at the end of cord to the Quick...
  • Page 13: Inserting The Battery

    COMBO HEADSET is equipped with a quick 4. Put the battery chamber disconnect for convenience back into the headset only. (Figure 3-7). When it is time to replace the battery, a 3.2 Inserting the Battery warning signal will sound in your headset every 1.
  • Page 14: Setup

    CHAPTER 3: Installation 3.3.1 S 1: A 3 seconds you will hear a DJUSTING TO YOUR signal indicating the headset TELEPHONE is now in setup mode 1. To set up the headset to (Figure 3-10). your telephone, you need to adjust the termination switch.
  • Page 15: Step 2: Adjusting The Microphone Sound Level

    COMBO HEADSET 5. If there is no dial tone or seconds.) A signal will 3.3.2 S 2: A DJUSTING THE you cannot hear the sound indicate that you are exiting MICROPHONE SOUND LEVEL of your blowing, move the setup mode. If the headset The microphone sound level must switch through positions A- exits setup mode before you...
  • Page 16 CHAPTER 3: Installation Figure 3-13. Pressing the Mute Button. Figure 3-14. Adjusting the Microphone Volume. 3. Increase or decrease 4. Press the mute button again microphone volume by to exit the setup mode. If pressing the upper (+) or you forget, the headset will lower (-) part of the oval automatically exit the setup volume control button until...
  • Page 17: Using The Headset

    COMBO HEADSET 4. Using the Headset from full power or “active” mode to “stand-by” mode. It After you have completed Steps 1 will stay in stand-by mode for 30 minutes. If the unit is and 2 described in Sections 3.3.1 not reactivated within the and 3.3.2, you are now ready to 30 minute period, it will...
  • Page 18: Muting The Microphone

    CHAPTER 4: Using the Headset 4.4 AVS (Advanced Voice Shaping) NOTE Do not force the boom over 1. AVS enhances sound when the top of the headset (Figure 4-3). calls are difficult to hear because of background noise. With AVS, you optimize the sound of the other person’s voice.
  • Page 19 COMBO HEADSET 4. To relieve the weight of the cord, attach the clip to your shirt or jacket (Figure 4-6). Figure 4-4. Adjusting the Length of the Headband. Figure 4-7. Reconnecting the Quick Disconnect. 3. Adjust the flexible 6. To clean or change the microphone boom so the microphone cushion, just microphone is positioned...
  • Page 20 CHAPTER 4: Using the Headset Figure 4-8. Removing the Ear Cushion.
  • Page 21: Troubleshooting

    It contains no user-serviceable • Replace the battery. I cannot hear the other person: parts. Contact Black Box at 724- 746-5500. People have a hard time hearing me: • Adjust the receive volume (refer to Section 4.2).
  • Page 22: Shipping And Packaging

    Before you turning the computer on or after walking across a carpet, ship, contact Black Box to off. causing no harm to the user. This get a Return Materials discharge is entirely due to the...
  • Page 23 Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500) FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746 Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018 Web site: www.blackbox.com • E-mail: info@blackbox.com...

Table of Contents