Transport And Storage - Bosch Rexroth IMpdp Manual

3 609 929 B40/2008-09 | IMpdp

5 Transport and storage

Device description
The following data rates (baud rate in kbit/s)
are supported: 9.6; 19.2; 45.45; 93.75;
187.5; 500; 1,500; 3,000; 6,000; 12,000.
5
1
9
Fig. 1: IMpdp interface module, front view
(socket)
1 OP LED (operation mode)
2 Interface
3 ST LED (status)
4 Screws
Interface connection assignment
Table 1
Pin Signal
1 Free
2 Free
3 B
4 RTS
5 GND bus
6 + 5 V bus 5 volt power supply
7 Free
8 A
9 Free
Housing Shield
2
1
3
5
6
Description/Function
Receive/send data plus
RxD/TxD (RS-485)
Send request
Ground
Receive/send data
minus
RxD/TxD (RS-485)
Connected to shield
Wired with protective
ground
Suitable connection plugs
Connection plugs in accordance with
Profibus standard IEC 61158.
Display elements
The OP LED indicates the Profibus operating
mode.
Table 2
LED display
4
Off
Green
Flashing green
Flashing red (1 Hz) Parameterization error
Flashing red (2 Hz) Profibus configuration error
The ST LED indicates the Profibus status.
Table 3
LED display Meaning
Off No voltage or not initialized
Green Ready for operation
Flashing Ready for operation, diagnoses
green available
Red Exception error
5 Transport and storage
For storing and transporting the product
always observe the ambient conditions
specified in the technical data (see
"Technical data" on page 25).
Bosch Rexroth AG
Meaning
No connection to master or
no voltage
Online, connection to master
established, data exchange
takes place
Online, connection to master
established, no data
exchange
19/76