Connect Plc - Siemens SIMATIC HMI TP 070 Equipment Manual

Installation
8.2.2

Connect PLC

Connection configuration
Figure 8-3 illustrates the basic connection possibilities between the operating unit
and PLC. The connection displayed is established by means of a PC-PPI cable.
Operating unit
IF1B
1)
Only use approved cables for connection to the SIMATIC S7.
Figure 8-3
The following components have been approved for connecting the TP 070 to the
SIMATIC S7:
MPI cable
SINEC L2 bus terminal RS485
SINEC L2 bus connector (even)
SINEC L2 bus connector (curved)
SINEC L2 FO bus terminal
'_' = Length code
8-8
RS485
Connection configuration for PLCs
SIMATIC
1)
S7–200
Order no.: 6ES7901–0BF00–0AA0
Order no.: 6GK15000–0A_006
Order no.: 6GK15000–0EA00
Order no.: 6ES7972–0B20–0XA0
Order no.: 6GK15000–1A_00
TP 070 Equipment Manual
Release 03/00