Advertisement
DIRECTIONS FOR USE
SET UP
Select a firm, level, flat location - at least six inches (15 cm) from any wall or object for proper air flow.
Place the humidifier on a water-resistant surface, as water can damage furniture and some flooring.
Do not place unit directly on carpet, towels, blankets or other absorbent surfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING -
Make sure unit is unplugged.
1. Separate the tank from the base of the unit.
3. Pour cool, clean water directly into the
tank. Do not pour anything but water
into the tank.
5. Attach the tank to the base of the unit
and plug in.
E-6
2. Flip over water tank and open the tank
lid, turning it to the left.
4. Close the tank lid, turning it to the right.
It is important to FIRMLY secure cap
after filling the tank with water.
POWER
4. Power Button
Before turning on make sure there is
water in the unit. Press the Power button.
DIRECTIONS FOR USE
CONTROL OPERATION
LIGHT
1. Night Light Feature
Press the Night Lamp button to turn
night light on/off.
L
M
H
3. Mist Control button
When you press the Mist Control button
there are three options: Press once for LOW
Press twice for MEDIUM*
Press three times for HIGH
*Medium is default setting.
REFILL
WARM MIST
5. Water Refill Indicator
When the unit is low on water the Refill LED
on the front panel will light up, and the unit
will shut off. Simply add more water to continue
use. Unit will automatically resume running
when water tank has been refilled.
NOTE: The humidifier is equipped with a safety device that will automatically shut the unit off when
activated. To restart, unplug for 5 sec/replug then press the power button. If the unit continues to shut
down, there may still be an abnormal condition and the unit may need service. Call Customer Service
4
8
12
2. Timer
Press the Timer button to select either 4, 8,
or 12 hours. The unit will turn off in that time.
REFILL
WARM MIST
4. Cool or Warm Humidification Indicator
Press to select cool or warm mist. When warm
is selected, LED will light. Water temperature is
maintained at room temperature for cool setting
and 80 degrees for warm. Allow 15 minutes for
water to warm.
Rotates
separately
6. Humidity Spout Dual Direction
Broaden mist in two different directions
throughout the room by rotating top section.
E-7
Advertisement
