Sony Ericsson K608i Manual page 37

Tips when recording and using voice
commands
If your phone cannot detect your voice command,
one of the following might have happened:
• You spoke too softly – try speaking louder.
• You held the phone too far away – hold it as you
do during a call.
• The voice command was too short – it should
be around one second long and more than
one syllable.
• You spoke too late or too soon – speak
immediately after the tone.
• You did not record the voice command when
the handsfree was attached – for voice control
with a handsfree kit, record when the
handsfree is attached.
• You used another intonation – use the same
intonation as in the recorded voice command.
Diverting calls
If you cannot answer incoming calls, you can divert
them to another number, for example, your
answering service.
When the Restrict calls function is activated, some
Divert calls options are not available.
P P reflighted by Preflighted by reflighted by
( ( ( ) ) )
You can choose between the following divert
options:
Divert always
• – divert all calls.
When busy
• – divert calls if you are already on
the phone.
Not reachable
• – divert calls if your phone is
turned off or if you are unreachable.
No reply
• – divert calls that you do not answer
within a specified time limit.
To activate a call divert
1
} Settings }
the Calls tab
or to scroll between the tabs.
2
Select a call type and then one of the divert
} Activate.
options
3
Enter the phone number to which you want
your calls to be diverted, or press
} OK.
find the contact
To deactivate a call divert
}
Scroll to the divert option
To check all divert options
} Settings } the Calls tab } Divert calls } Check
Use or to scroll between the tabs.
Calling
} Divert
calls. Use
Look up
to
Deactivate.
all.
37