Toshiba Satellite Pro 6100 Series Quick Start Manual page 12

FIELD REPLACEABLE UNIT DOCUMENTATION
14.1" DISPLAY MASK REMOVAL
Mask seals
1. Remove two mask seals at the bottom corners of the
display assembly using a pair of fine-tipped tweezers.
2. Remove two M2.5x6 black flat head screws securing
the display mask.
3. There are 23 latches securing the display mask.
Carefully insert your fingers between the mask and the
LCD panel and pry open the latches starting from the
six top latches, to the five latches on each right
and left sides, ending with the bottom seven latches.
Satellite Pro
6100 Series
Latch
Display
mask
LCD
TOSHIBA
Tough Enough for Today's World.
TM
FL INVERTER AND 14.1" LCD REMOVAL
M2x3
silver
screws
M2x5
silver
screws
LCD/
FL harness
FL inverter board
1. Remove one M2x4 silver screw securing the
FL inverter board.
2. Carefully lift up the FL inverter board and
disconnect the LCD/FL cable from CN1 and the
FL cable from CN2.
3. Remove four mask seals to expose four screws
securing the LCD module assembly.
4. Remove four M2X5 silver screws securing the
LCD module assembly.
5. Carefully rotate out the top of the LCD module
enough to access the display cable
6. Peel off the tape securing the LCD/FL cable and
disconnect the cable.
7. Remove four M2x3 silver screws securing the
right and left LCD brackets.
LCD module assy
M2x3
silver
screws
M2x5
silver
screws
M2x4 silver screw FL cable