Top Cover Assembly
/ Door Switch
Sensor Pressure
Switch
Downloaded from
Hudson Washer.indb 13
www.Manualslib.com
Part
manuals search engine
Figure
1. Remove the 2 screws from the cover
2. Separate the control panel assembly.
3. Separate the Assy Valve Water, the main
4. Separate the main wire harness, the
5. Release the bleach hose clamp.
6. Separate the top cover assembly by
7. you can check the door switch If turn the
1. Disassemble the control panel assembly.
2. Separate the pressure switch housing.
3. Before separating the hose, release the
Description
plate.
PBA, the Assy Sensor Pressure and the
filter EMI housing.
Separate the housing to prevent
stress and damage to the wire-
harness.
pressure switch hose clip , Grounding
screw .
lifting and pushing ahead the top part of
the assembly.
Top cover upside down.
clip.
When releasing the clip, take care
that you do not tear the hose.
Disassembly and Reassembly _ 13
2012-03-28
9:45:53