Table of Contents
Advertisement
A
combination antenna receives normal
broadcast channels (VHF 2–13 and
UHF 14–69). Your connection is easy
because there is only one 75Ω (ohm)
antenna plug on the back of your TV, and
that's where the antenna goes.
1
If your antenna has a round cable
(75 ohm) on the end, then you're ready
to connect it to the TV.
If your antenna has flat, twin-lead
wire (300 ohm), you first need to
attach the antenna wires to the screws
on a 300- to 75-ohm adapter.
2
Push the round end of the adapter (or
antenna) onto the 75Ω (ohm) plug on
the back of the TV. If the round end of
the antenna wire is threaded, screw it
down finger tight.
3
Plug the television in to the wall out-
let and turn the TV on. Refer to the
TUNER and AUTOPROGRAM features
on page 3 of this Quick Use Guide.
TUNER should be set to the ANTENNA
option. AUTOPROGRAM can be set to
program all the available channels on
your cable signal into the television's
memory.
c c C
I
HECK
After using the AutoProgram Control, press
the CH + and – buttons to scroll through all
the channels stored in the television's mem-
ory.
B
A
ASIC
NTENNA
Antenna Connection:
The combination antenna receives normal
broadcast channels 2-13 (VHF) and 14-69 (UHF).
O
T
UT
T
C
ELEVISION
Outdoor or Indoor Antenna
(Combination VHF/UHF)
300 to 75-ohm
Adapter
1
Twin
Lead Wire
Round 75Ω
Coaxial Cable
from Antenna
6
ONNECTION
Back of TV
75
3
2
Power Plug
from back of TV
Jack Panel
Back of TV
AC Power
Wall Outlet
Advertisement
Table of Contents
