Tips - Philips 28PW9308/05 User Manual

Tips

Care of the screen
Poor Picture
No picture
No sound
No solution found
for your picture or
sound problem ?
Remote control
Menu
Standby
Clean the TV with a slightly damp soft cloth. Do not use abrasive solvent as it can
damage the TV screen.
• Have you selected the correct TV system in the manual installation menu ?
• Is your TV or house aerial located too close to loudspeakers, non-earthed audio
equipment or neon lights, etc.?
• Mountains or high buildings can cause double pictures or ghost images.
Sometimes you can improve the picture quality by changing the direction of the
aerial.
• Is the picture or teletext unrecognisable? Check if you have entered the correct
frequency. See Installation, p. 6.
• Are brightness, sharpness and contrast out of adjustment? Select Factory
settings in the Setup, General menu, p. 7.
• Sometimes poor picture quality is possible when having activated an S-VHS
camera or camcorder connected to the right side of your TV and another
peripheral is connected to
off one of the other peripherals.
• Is the aerial connected properly?
• Are the plugs tightly connected in the aerial socket?
• Is the aerial cable in good condition and does it have suitable plugs?
• No sound on any channel? Check the volume isn't at minimum.
• Is the sound interrupted with the mute key ¬?
Switch your TV off and then on again once. Never attempt to repair a defective
TV yourself. Check with your dealer or call a TV technician.
• If your TV no longer responds to the remote control, the batteries may be dead
or the wrong mode (TV or other peripheral, see p. 3) is selected.
• You can still use the
Have you selected the wrong menu? Press the
the menu.
Your TV consumes energy in the standby mode. Energy consumption contributes
to air and water pollution.
Power consumption: 1 W.
or at the same time. In this case switch
EXT 1 2
key and the -/+ keys at the top of your TV.
MENU
Ï key again to exit from
MENU
17