b) touch panel
4. Perform the following steps to remove the power connector.
a) Release the power connector cable from under the display hinge [1].
b) Remove the screw that secures the power connector to the palmrest assembly.
c) Lift the power connector off the palmrest assembly [2].
Installation du connecteur d'alimentation
1. Serrez la vis qui fixe le connecteur d'alimentation à l'ensemble repose-mains.
2. Faites passer le câble du connecteur d'alimentation sous la charnière de l'écran.
3. Connectez les câbles suivants à la carte système :
a) panneau tactile
b) connecteur d'alimentation
4. Installez :
a) la batterie
b) le cache de fond de l'ordinateur
5. Appliquez les procédures décrites dans Après une intervention à l'intérieur de l'ordinateur.
Removing the Input/Output (I/O) Board
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a) base cover
b) battery
c) WLAN card
d) coin-cell battery
3. Perform the following steps to remove the I/O board:
a) Disconnect the I/O board cable from the system board and the I/O board.
b) Disconnect the camera, fan, and coin-cell battery cables from the I/O board.
c) Remove the screws that secure the I/O board to the computer.
d) Lift the I/O board from the computer.
20
Retrait et installation de composants