Parking Brake Use; Frost Plug Heater; Burner - Generac Power Systems MAC MIH400HC Owner's Manual

Indirect fired heat cart
Table of Contents

Advertisement

Before towing, verify the following:
The coupling, tires, and wheels are in working
order.
Wheel lug nuts are tightened to 100 ft-lbs (135.6
Nm).
While towing, make regular stops to verify the following:
Coupler is secured to the hitch and locked.
No damage or unusual wear to tire treads or side-
walls.
Cart and doors are latched and secured.

Parking Brake Use

WARNING
Crushing hazard. Verify parking brake is properly
secured and unit is on level ground. An unsecured
unit could suddenly roll or move, and could result in
death, serious injury, or equipment damage. (000352)
CAUTION
Pinching and crushing hazard. To avoid
possible injury, keep fingers away from pivot
point when folding or unfolding trailer tongue.
See
Figure
2-1. Engage the parking brake by raising the
tow bar to the locked position. The locking lever (A) holds
the tow bar in place. Do not operate the unit without the
parking brake engaged.
Lift up the locking lever and slowly lower the tow bar to
disengage the parking brake. Do not attempt to move the
unit with the parking brake engaged; equipment damage
may occur.
A
Figure 2-1. Parking Brake Engaged
Owner's Manual for Indirect Fired Heater

Frost Plug Heater

The unit is equipped with a frost plug heater (see
Table 1: External
ciency in extreme temperatures. The frost plug heater
warms the battery blanket and oil pan before starting, to
improve starting and operation.

Burner

The burner runs on diesel fuel drawn from the fuel tank.
Unused fuel is returned to the fuel tank.
The burner reset button is located in the upper-center of
the burner cover. Press the burner reset button:
If the burner control box indicates a fault.
As part of annual maintenance.
For more information, see the burner manual.
(000313)
003955b
General Information
Components, letter N) to improve effi-
11

Advertisement

Table of Contents
loading

Table of Contents