Download
Share
Print this page
Pentair Pool Products AquaLuminator Owner's Manual
  1. Manuals
  2. Brands
  3. Pentair Pool Products Manuals
  4. Swimming Pool Lighting
  5. AquaLuminator
  6. Owner's manual
Pentair Pool Products AquaLuminator Owner's Manual

Pentair Pool Products AquaLuminator Owner's Manual

Light and return water flow for above ground pools
Hide thumbs

Advertisement

Quick Links

Download this manual

Advertisement

loading

Related Manuals for Pentair Pool Products AquaLuminator

Summary of Contents for Pentair Pool Products AquaLuminator

  • Page 2: Table Of Contents

    ® AquaLuminator Light and Return Water Flow for Above Ground Pools Owner's Manual IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS Table of Contents SECTION I. IMPORTANT SAFETY INSTRUCTIONS ............2 SECTION II. LAMP HOUSING INSTALLATION ..............2 SECTION III.

  • Page 3: Section I

    SECTION I. IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following. This light can be installed on storable above ground or permanent above ground pools. To reduce the risk of electric shock, if any cord becomes damaged, return the entire transformer assembly for repair or replacement.
  • Page 4 5. Place a winterizing plug in the front side of the existing return fitting and disconnect the return hose and clamp from the existing fitting. Return Fitting 6. Place a winterizing plug in the front side of the AquaLuminator threaded Figure 3. wall flange.
  • Page 5 11. With the inlet port of the fitting body in the 3 O’clock position, place the fitting body against the threads of the flange and keeping the inlet port in the 3 O’clock position; see Figure 6. Hand tighten the flange as tight as possible.

  • Page 6: Electrical Connections For Storable Pools

    SECTION III. ELECTRICAL CONNECTIONS FOR STORABLE POOLS Keyway Connect the wire connectors from the bulb assembly to the wire connectors attached to the snap-on cord cap. NOTE There is no polarity (no positive or negative) to the wires, either connection will work. Snap the cap onto the end of the body and turn so that the O-Ring—use silicone lubricant electrical cord is pointing down.
  • Page 7 3. Remove the snap-on cord cap by inserting a slotted screw driver into the access hole as illustrated in Figure 9 and prying upwards. 4. Disconnect both wire connectors and put the snap-on cord cap aside in a dry location and remove the bulb assembly nut. 5.

  • Page 8: Storage And Winterizing Instructions

    12. Reconnect the power to a circuit in accordance with the appropriate electrical connections. See Section III, Electrical Connections. If the light is not on, press the switch on the transformer case once. WARNING This is an electrical appliance. Unsupervised use of this product by children can result in injury and/or death.

  • Page 9: Replacement Parts

    This document is subject to change without notice. ® ® Trademarks and Disclaimers: AquaLuminator and Pentair Water Pool and Spa are trademarks and/or registered trademarks of Pentair Water Pool and Spa Inc. and/or its affiliated companies in the United States and/or other counties. Unless noted, names and brands of others that may be used in this document are not used to indicate an affiliation or endorsement between the proprietors of these names and brands and Pentair Water Pool and Spa, Inc.
  • Page 10 www.quimiapool.com Ingenierie, S.A. de C.V. E-mail: direccion@quimiapool.com Tel. 5 537 9147 y 556 413 0072 Gardenias 1, Santa María Palapa, San Martín de las Pirámides, Edo. Méx. CP. 55851...