babymoov Turbo Steam+ Instructions For Use Manual page 10

STERILISER
1. Remove the drip tray (j) under the appliance.
2. Open the lid (c).
3. Take out the tree assembly thanks to its handle (d) and place it on the drip tray (j).
4. Fill the measuring cup (n) with fresh and clean water. Pour the water into the heater tank (k).
5. Place the tree assembly into the appliance. Place the bottles upside-down on the steam branches (g) so that the steam can
enter the bottles directly. Arrange the teats and rings onto the small double branches (h) on the base of the appliances (i).
Put the caps on the little branches at the top of the tree assembly (e).
6. Place the lid onto the appliance.
7. Plug in the steriliser to mains power, press the On/Off button (m), then the sterilisation start button (l).
8. The steam will go out through the steam branches (g), the central trunk (f) and the bottom of the appliance, ensuring a
complete sterilisation. A power indicator will light up, showing that the steriliser is working.
9. When the sterilisation cycle is complete, an alarm will sound and the sterilisation indicator (l) will turn off. However, the
steriliser is still powered on until the On/Off switch (m) is switched off. Open the lid thanks to its handle (a) and remove the
bottles carefully: they will be very hot. Always allow the appliance to cool between the cycles or prior to handle the bottles
and accessories.
DRAINING RACK
- Place the tree assembly on the drip tray (j).
- Wash your bottles carefully.
- Put the bottles and accessories on the branches of the tree assembly.
- The remaining water will flow on the white base and be collected by the drip tray.
TURBO STEAM + ELECTRIC STERILISER • Instructions for use
10
a. Lid's handle
b. Steam hole
c. Lid
d. Tree's handle
e. Branches for caps
f. Central trunk
g. Steam branches
h. Double branches
for teats and rings
i. Base
j. Drip tray
k. Heater tank
l. Sterilisation start button
HOW TO USE
n. Water cup
m. On/Off switch