Warning Concerning Stationary Images On The Tv Screen - Philips 32PF5531D/10 User Manual

Troubleshooting Tips
Symptom
Unable to understand • Wrong language selected
the language on
screen to operate set
Cannot access Install
menu
PC modes do not
work
S-Video colour
becomes faint
Black bar on top
and bottom of
screen in PC mode
Cannot access digital
menu
Some channels or no
channels are found
after channel scan

Warning concerning stationary images on the TV screen

A characteristic of Plasma Display Panels is that displaying the same image for a long time can
cause a permanent after-image to remain on the screen. This is called phosphor burn in.
Normal use of the TV should involve the showing of pictures that contain constantly moving
and changing images that fill the screen.
32
Possible Causes
accidently
• AV EXTERNAL or HD
mode is selected.
• Wrong connections
• Wrong source selected.
• Wrong display resolution
• Wrong setting of PC
graphic card
• Wrong detection of
signal
• PC refresh rate too high
• Still in Analogue mode
• TV antenna not properly
connected to the digital
equipment
• Antenna wall socket
may be damaged
What you should do
• Press the key to exit menu from screen.
Press the key again to display menu.
Press the ï key to select the menu second item on the
menu and the Æ key to enter into the next menu level.
Press the Æ key again and use the
fifth menu item.
Press the Æ key enter into the next menu level.
Use the Î ï keys to to select correct language.
Press the key confirm selection.
OK
Press the key to exit menu from screen
• Press AV key and select TV mode. You can now
access Install menu by the
key.
• Check whether connections are correct.
(For more details on connection to the PC
equipment, see "Connection Guide".
• Check whether the source is correctly selected.
Press button to enter Source list and select
the correct source.
•
Check whether you have configured the computer on
a compatible display resolution (see
as PC Monitor" on page 29)
• Check graphic card setting of PC.
• Check whether power cord is properly connected
• Press the P +/– key on the remote control and do a
channel up followed by a channel down.
• Change PC refresh rate to 60 Hz.
• Press the key to switch to Digital mode.
• Check connection of TV antenna to digital equipment.
• Check condition of antenna wall socket and replace
if antenna wall socket is damaged.
ï key to select the
(analogue TV menu)
"Using your TV
.