Advertisement
C
/C
ABLE
ABLE
Your Cable TV input into your home may be a single (75 ohm) cable
or use a cable box decoder. In either case the connection is very
simple. Follow the steps below to connect your cable signal to your
new television.
Direct Cable Connections:
This connection will supply Stereo sound to the TV.
1
Connect the open end of the round Cable Company supplied
cable to the 75
Ω
input on the bottom of the TV.
Cable Box (w/RF In/Outputs):
This connection will NOT supply Stereo sound to the TV. The sound
from the cable box will be mono.
1
Connect the open end of the round Cable Company supplied
cable to the cable signal IN(put) plug on the back of the Cable
Box.
2
Using a separate round coaxial cable, connect one end to the
OUT(put) (TO TV) plug on the back of the Cable Box.
3
Connect the other end of the round coaxial cable to the 75
input on the bottom of the television.
NOTE: Be sure to set the OUTPUT CHANNEL SWITCH on the
back of the cable box to CH 3 or 4, then tune the cable box on the
TV to the corresponding channel. Once tuned, change channels at
the cable box, not the television.
Cable Box (w/Audio/Video Outputs):
This connection will supply Stereo sound to the TV.
1
Connect the open end of the round Cable Company supplied
cable to the cable signal IN(put) plug on the back of the Cable
Box.
2
Using an RCA type Video Cable, connect one end of the cable
to the Video (yellow) (or ANT, your cable box may be labeled
differently) Out jack on the cable box and the other end to the
Video In jack on the bottom of the TV.
3
Using an RCA type Audio Left and Right Cable, connect one end
to the left and right Audio Out L & R jacks (red & white) on the
cable box and the other ends to the Audio In L & R jacks on the
bottom of the TV.
NOTE: Use the AV button and the CURSOR DOWN/RIGHT
on the TV remote control to tune to the AV channel for the cable
box signal. Once tuned, change channels at the cable box, not the
television.
B
TV
OX
Cable Box with RF Inputs and Outputs Connection:
Ω
Cable Box with Audio/Video Outputs Connection:
Cable Signal IN
from the Cable
Company
Direct Cable Connection:
Jack Panel Bottom of TV
1
2
Jack Panel Back
of Cable Box
Round 75Ω
Coaxial Cable
Cable Signal IN from
the Cable Company
1
3
Audio Cables L & R
(Red, White)
Video Cable (Yellow)
2
Cable signal coming from
Cable Company (Round
75Ω coaxial cable)
1
Output Channel Switch
Jack Panel Bottom of TV
Jack Panel Back of Cable
Box with A/V Outputs
Jack Panel Bottom of TV
3
Advertisement
