Adjusting the picture preferences
You can select your desired picture type from three preset picture
modes: Normal, Theater, and Memory.
To select the picture preferences:
1. Press MENU, then press x or • until the PREFERENCE menu
appears.
2. Press y or z to highlight PICTURE PREFERENCE.
3. Press x or • to highlight the mode you want.
The table below describes the effects of the different preferences.
Mode
Picture Quality
normal
picture quality set at factory
theater
movie-like picture setting
memory
your personal preference*
*(see "Adjusting the picture quality" on page 30)
Using the flesh tone feature
This feature allows you to obtain natural flesh tones by correcting the
difference of tint between TV stations.
To turn on the flesh tone feature:
1. Press MENU, then press x or • until the PICTURE menu
appears.
2. Press y or z to highlight FLESH TONE.
3. Press x or • to highlight On.
PICTURE
AUDIO
SET UP
PREMIUM
SBS
PREFERENCE
C.CAPTION
F LESH TONE
On
Off
NO I SE REDUCT I ON
On
START
CONVERGENCE
PUSH
To end push EXIT
To turn off the flesh tone feature:
Choose Off in step 3 above.
Using the noise reduction feature
This feature allows you to reduce visible interference in your TV
picture. This is useful when receiving a broadcast with a weak signal
or playing back a video cassette or disk damaged by repeated use.
To turn on the noise reduction feature.
1. Press MENU, then press x or • until the PICTURE menu
appears.
2. Press y or z to highlight NOISE REDUCTION.
3. Press x or • to highlight On.
PICTURE
AUDIO
SET UP
PREMIUM
SBS
PREFERENCE
C.CAPTION
F LESH TONE
On
NO I SE REDUCT I ON
On
Off
START
CONVERGENCE
PUSH
To end push EXIT
To turn off the noise reduction feature:
Choose Off in step 3 above.
MTS
TV
CABLE
1
2
4
5
7
8
100
0
MENU/
FAV
-
ENTER
MUTE
RECALL TV/VIDEO SURROUND
31
POWER
TIMER
VCR
3
CH
6
9
VOL
CH RTN
ENT
ADV
MENU
FAV
+
y z x •
ADV