Advertisement
INSTALLATION
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation. Refer to
SHIPPING DAMAGE CLAIM
PROCEDURE on the inside
front cover of this manual.
WARNING:
RISK OF
INJURY
Installation procedures must
be performed by a qualified
technician with full knowledge
of all applicable electrical and
plumbing codes. Failure can
result in personal injury and
property damage.
IMPORTANT:
This appliance must be
plugged into a properly
grounded receptacle.
Contact a licensed electrician
to install and connect a proper
receptacle.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.
IMPORTANT:
DO NOT run Hydro-Surge
dry. Operating the unit dry will
damage the seals and allow it
to leak.
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all protective
plastic film, packing materials and accessories from the Appliance
before connecting electrical power or otherwise performing any
installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before discarding
packing materials. Store all accessories in a convenient place for later
use.
COMPONENTS
1 ea
1 ea
1 ea
1 ea
INSTALLATION
IMPORTANT: Layout, installation and any conversion to be performed
by a qualified service technician only.
Layout mounting holes per Installation Instruction. After completing
cutout operations, carefully deburr all holes.
NOTE: Hydro-Surge unit is designed to mount on the LEFT side of the
wash tank. If mounting to the right side:
a. Rotate motor until switch is accessible from the front.
b. Remove and reinstall motor connector box cover so that switch
markings are right-side-up.
NOTE: The 120 volt Hydro-Surge part no. 20621 is shipped from the
factory wired for 120 volts AC, 60 Hz. If unit is to be used for 240 volts:
a. Purchase part no. 2E-35540 240 VAC power cord.
b. Reconfigure motor wiring connections per motor label as
required for 240 VAC.
c. Install 240VAC power cord. Be sure to tighten strain relief.
IMPORTANT: 240V conversion is not UL Listed.
Apply a thin bead of food-grade silicone sealant to one face of the
gasket, then apply gasket to the mounting plate of the motor assembly.
Apply a thin bead of food-grade silicone sealant to the exposed face
of the gasket, then assemble the motor and pump housing to the
wash tank. Test impeller to be sure it rotates without contacting the
pump housing. Adjust as necessary. Bolts need be only tight enough
to prevent leaks. Over-tightening is not necessary Install the cover.
Thumbscrews need only be finger-tight.
Fill wash tank. Plug unit into a appropriate receptacle and test for
proper operation.
6
MOTOR ASSEMBLY
GASKET, TANK TO MOUNTING PLATE
PUMP HOUSING ASSEMBLY
COVER
HARDWARE and LITERATURE
Advertisement
