Table of Contents
Advertisement
3.2 System Information
You can display system settings information as shown on Table 3.2 A below at any time by pressing
the DISPLAY button
must first switch the unit to encoded image displaying (The pictures is switching swiftly and the light
of MUX/ DVR button
DISPLAY button displays a different message detailed in the following example. By default, the unit
displays time, date, and an indicating bar of capacity status on a monitor as shown next.
Default display
(Capacity Used)
09- 05-2001
(Date)
Press the DISPLAY button once; the unit will display the following sample message plus the default
display. Press the DISPLAY button again; the unit will not display any OSD message. Press the button
one more time to back to the default display.
Table 3.2 A.
HD 1+HD 2: 76G
QUALITY: HIGH
RATE: 6 HR
HD P
SIZE
1
Y
38 G
2
Y
38 G
3
.
.
. However, when the unit is displaying a decoded image from a multiplexer, you
is off) by pressing the MUX/ DVR button . Each sequential press of the
(Capacity Remaining)
16:13:02
(System Time)
11.2 HR
NTSC
20 F/S
POS
2.5%R (P)
0%R (P)
Description of Table 3.2 A
(HD1+HD2: 76GB): Total capacity of installed hard disk, 76 GB
Total 11.2 hour minimum guaranteed recording
(11.2 HR):
time available. Actual recording time may be
longer in everyday use.
(
): Timer record activated
(
): Alarm record activated
(QUALITY: HIGH): Record quality setting, HIGH
(NTSC): NTSC system
(RATE: 6 HR): Setting of Record time mode, 6 hours
(20 F/S): Record speed setting, 20 fields/sec
(HD): Hard disk Compartment
(P): Y Hard disk installed; . No hard disk installed
(SIZE 38GB): The capacity of the installed hard disk
POS: Percentage of system; R: Recording; P: Playback
14
Advertisement
Table of Contents
