Getting Started; Inserting Batteries; Finding Your Viewing Channel; Setting The Language - Toshiba SD390EKB Owner's Manual

Inserting Batteries

Open the battery compartment.
A
Insert two batteries type R03 or AAA, following the
B
indications (+ / - ) inside the compartment.
Close the cover.
C
CAUTION:
- Never throw batteries into a fire.
- The batteries shall not be exposed to excessive heat
such as sunshine, fire or the like.
Note:
- Be sure to use AAA size batteries.
- Dispose of batteries in a designated disposal area.
- Batteries should always be disposed of with the
environment in mind. Always dispose of batteries in
accordance with applicable laws and regulations.
- If the remote control does not operate correctly, or if
the operating range becomes reduced, replace batteries
with new ones.
- When necessary to replace batteries in the remote
control, always replace both batteries with new ones.
Never mix battery types or use new and used batteries
in combination.
- Always remove batteries from remote control if they
are dead or if the remote control is not to be used for an
extended period of time. This will prevent battery acid
from leaking into the battery compartment.
Using the Remote Control to Operate
the System
30
Within about 6m (19 feet)
Aim the Remote Control directly at the remote sensor
A
(IR) on the front panel.
Do not put any objects between the Remote Control
B
and DVD Player while operating the DVD Player.

Finding your viewing channel

Press I/2ON/STANDBY on the DVD player to turn it
A
on.
Turn on the TV and set it to the correct video-in
B
channel. You should see the blue DVD background
screen.
Usually these channels are between the lowest
Helpful hint: Press  to go back to previous menu item.
30
Press SETUP to exit the menu item.

Getting Started

and highest channels and may be called FRONT,
A/V IN or VIDEO. See your TV' s manual for more
details.
Or, you may go to channel 1 on your TV, then
press the Channel down button repeatedly until you
see the Video In channel.
Or, the TV remote control may have a button that
chooses different video modes.
Or, tune the TV until you can see the DVD player
signal from the RF modulator (refer to your TV user
manual).
If you are using external equipment, (such as
C
audio system or receiver), turn it on and select the
appropriate input source for the DVD player output.
Refer to the equipment user's manual for detail.

Setting the language

Choose your desired On-Screen Display(OSD)language
where available.
On-Screen Display (OSD) Language
The On-screen language for the system setup menu
will remain as you set it, regardless of various disc
languages.
OSD language
Language
Subtitle
Audio
Video
DVD Menu
Audio
Rating
Misc
Press SETUP.
A
Press / to select { Language }
B
Press  to highlight { OSD language }, then press
C
.
Press / to select a language and press OK to
D
confirm.
Audio, Subtitle and DVD menu
language
You can choose your own preferred language or
soundtrack from audio, subtitles and DVD menu
languages. If the language selected is not available
on the disc, the disc's default language will be used
instead.
OSD language
: English
Language
Subtitle : Off
Video Audio
DVD Menu
Audio
Rating
Misc
Press SETUP.
A
Press / to select { Language }, then press .
B
Press / to highlight one of the options below,
C
then press .
English
Français
: English
Espanol
Deutsch
:
English
Italiano
English
French
Spanish
German
Italian