Part 3. Operation; How To Use The Ait Drive - Sony SDX-D500C Operator's Manual

Ait drive unit
Hide thumbs Also See for SDX-D500C:
Table of Contents

Advertisement

Available languages

Available languages

Part 3. Operation

How to use the AIT Drive

This section describes how to use the AIT drive, and how to handle data
cartridges.
1
Press the POWER switch on the front panel.
The POWER indicator should light, and the STATUS, BUSY and TAPE
indicators should blink as the self-test is performed.
2
When the three indicators stop blinking, you can insert a data cartridge
as shown below. The TAPE indicator will blink, and if the cartridge is
write-protected, the STATUS indicator will light.
Figure 3-1. Inserting a data cartridge
3
Computer software controls the reading and writing of tapes. While
reading or writing, the BUSY indicator blinks.
15
Part 3. Operation

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sdx-d400c

Table of Contents