Safety Instructions - Neoware eon 5000 Series User Manual

Safety Instructions

Please read these safety instruction carefully and keep this user's manual for later refer-
ence.
1. Before removing the outer case from the Eon always disconnect the AC power cord to pre-
vent the possibility of dangerous electrical shock.
2. Before cleaning, disconnect the Eon from AC power. Do not use liquid or sprayed cleaning
products to clean the unit. Instead, use a moistened sheet or cloth for cleaning.
3. Be sure not to expose the Eon from excessive humidity.
4. Be sure to install the Eon on a secure surface. A falling Eon could cause injury.
5. Place the power cord in such a way to avoid people stepping on it. Do not place anything
over the power cord.
6. Be sure to note all cautions and warnings on the Eon.
7. If the Eon is not used for a long period of time, disconnect the AC power to avoid damage
caused by voltage transients.
8. Never pour any liquid into any Eon openings: This could cause fire or electrical shock.
9. If one of the following situation occurs, be sure to get the Eon checked by a qualified ser-
vice technician:
a. The power cord or plug is damaged.
b. Liquid penetrates the Eon case.
c. The Eon is exposed to moisture.
d. The Eon does not work well or you cannot get it to work according to the user's man-
ual.
e. The Eon has been dropped or damaged.
f. If the Eon has obvious signs of breakage.
10. The Eon should be stored and used only in temperature and humidity controlled environ-
ments. Storing Eons below -20°C (-4°F) or above 60°C (140°F) may cause damage.
11. The sound pressure level at the operators position according to IEC 704-1:1982 is equal or
less to 70dB(A).
12. The input power cord shall be minimum H05VV-F, 3G, 0.75mm², rate minimum 6A.
13. The Eon should be used only where ambient air temperatures are maintained below 40°C.
vi Safety Instructions