Siemens RCR100FPRF Operating Instructions page 2

Receiver's LED indication
State of receiver
Power up (or reset)
Learning mode
Successful learning mode
Signal ok and output status change
Fail to receive wireless data
2/2 Operating Instructions
State of LED
The red and green LEDs flash alternately for 5 seconds, and then change to constantly red.
Note: If the receiver was programmed before, it will immediately change to constantly red.
The red and green LEDs flash alternately.
If RCR100FPRF learning was successful, the green LED will flash for 10 minutes.
The green LED is lit. If the output state changes, the green LED flashes for 3 seconds and then
changes back to constantly green.
If the RCR100FPRF fails to receive wireless data, the red LED will start to flash after 125 minutes.
If the RCR100FPRF signal is recovered, it will resume the previous LED state.
CB1B1433en_01 / 2013-07-05 Siemens Building Technologies