Setting The Clock; Setting The Auto Timer - Melitta ME10DTB Use And Care Manual

Thermal coffeemaker
Table of Contents

Advertisement

Brewing Instructions
opening at the back of the Base. The Water Reservoir will
snap into place as you press it firmly against the body of the
machine. Make sure the Removable Water Reservoir is
correctly positioned and in place before starting.
9. To replace the Carafe Lid, twist it until the Lid Lever is
opposite the Spout and sits directly over the Handle of the
Carafe. Make sure the Carafe Lid is properly secured onto
the Carafe. Place the Carafe onto the Base.
IMPORTANT: Always use fresh, cool water in your appliance.
Warm water or other liquids, except as listed in the Care and
Cleaning Instructions, may cause damage to the appliance.
NOTE: The amount of brewed coffee will always be less than the
amount of water placed into the Coffeemaker, since about
10% is absorbed by the coffee grounds and filter.
10. Locate the Cord Storage area at the bottom back of the unit.
Extend cord, fitting it into the bottom cord notch, and plug
the unit into a 120V, AC electrical outlet. The second hand
and AM/PM display on the bottom of the blue-lit analog
Clock will begin to flash. (See Figure 3.) Set the Clock
following the instructions below.

Setting the Clock

1. When you plug the unit in, the second hand and AM/PM
display will flash until the time of day is set.
2. To set the Clock, press the HR Button. Release the Button
when the correct AM/PM is displayed and the hour hand is at
the correct position. The second hand will begin sweeping
across the face of the clock to keep the time. Press the MIN
Button until the correct minutes are displayed.

Setting the AUTO Timer

1. Press the
Light will flash. Press the HR and MIN Buttons as described
in "Setting the Clock" section above, until the AUTO Timer is
set to the correct future brewing time.
2. Press the
Timer. The Clock will revert back to show the time of day.
The amber Light will glow steady to indicate the AUTO Timer
is ON.
SET TIMER Button. The amber SET TIMER
ON/OFF/AUTO Button to activate the AUTO
(Continued)
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents