Cadillac XTS 2019 Owner's Manual page 59

58 SEATS AND RESTRAINTS
Vehicle Personalization Settings
To have the Seat Entry Memory
movement begin when the vehicle
is started, select the Settings
menu, then Vehicle, then Seating
Position, and then Seat Entry
Memory. Select On or Off. See
Seat Entry Memory later in this
section.
To begin Seat Exit Memory
movement when the ignition is
turned off and the driver door is
opened, or when the ignition is
turned off with the driver door
already opened, select the Settings
menu, then Vehicle, then Seating
Position, and then Seat Exit
Memory. Select On or Off. See
Seat Exit Memory later in this
section.
See Vehicle Personalization 0 139
for additional setting information.
Identifying Driver Number
To identify the driver number:
1. Start the vehicle with a different
key or RKE transmitter. The DIC
should display the driver
number; 1 or 2. Turn the ignition
off and remove the key or RKE
transmitter from the vehicle.
2. Start the vehicle with the initial
key or RKE transmitter. The DIC
should display the other driver
number not shown in Step 1.
Saving Memory Positions
Read these instructions completely
before saving memory positions.
To save preferred driving positions
1 and 2:
1. Turn the ignition on or to ACC/
ACCESSORY.
A DIC welcome message may
indicate driver number 1 or 2.
2. Adjust all available memory
features to the desired driving
position.
3. Press and release SET; a beep
will sound.
4. Immediately press and hold the
1 or 2 memory button matching
the above DIC welcome message
until two beeps sound.
If too much time passes between
releasing SET and pressing 1, the
memory position will not be
saved and two beeps will not
sound. Repeat Steps 3 and 4.
1 or 2 corresponds to the driver
number. See Identifying Driver
Number previously in this
section.
5. Repeat Steps 1 4 for a second
driver using 1 or 2.
To save the position for
Exit Memory, repeat Steps 1 4 using
. This saves the position for getting
out of the vehicle.
Save preferred memory feature
positions to both 1 and 2 if you are
the only driver.
Manually Recalling Memory
Positions
Press and hold 1, 2, or
the previously saved memory
positions.
To stop Manual Memory Recall
movement, release 1, 2, or
any of the following controls:
and Seat
to recall
or press