Download Print this page

Maverick ET-84 Instruction Manual page 2

Voice alert thermometer

Advertisement

NOTE:
• The unit defaults to 2:00:00 (2 hours) cooking time for BEEF, PORK & VEAL and 4 hours for Poultry & PGM.
• As the roast beef begins to cook the unit will monitor and display the internal cooking temperature, the cooking time
and the cooking time left.
• The unit is monitoring the temperature rise overtime and will calculate an anticipated cooking time remaining. It is
the ONLY unit that anticipates when your food will reach the alert temperature.
• The bar graph will display a flashing PROCESSING and bar icons when the temperature is below 90"F. Once the
cooking temperature goes above 90°F the bar graph will display the cooking temperature as a percentage of alert
temperature in bar icons. As the bar icons remain on and fill from left to right the meat is getting closer to the alert
temperature.
30 minutes remaining: beep-beep for one minute
15 minutes remaining: beep-beep-beep for one minute
5 minutes remaining: beep-beep-beep-beep for one minute
0 minutes remaining: beep-beep continuously and the ALERT icon flashes
7. Press the ALERT STOP button to stop the beeping temporally or switch VOICE, BEEP, OFF switch to OFF to shut it
off permanently.
NOTE:
If the roast beef is left cooking and the cooking temperature goes to 170'F (10'F higher than the alert temperature)
then the unit will activate the OVERCOOK ALERT and will beep 8 times per second and the OVERCOOK & ALERT
icons will flash on the display.
• DURING COOKING THE CALCULATED "TIME REMAINING" DISPLAY MAY JUMP FORWARDS OR BACKWARDS
DUE TO FOOD VARIATIONS AND PROCESSING REQUIREMENTS. THIS WILL SELF ADJUST AS TIME
PROGRESSES.
TYPICAL COOKING WITH PRESET USDA DONENESS AND VOICE ALERT
Example: 15 Ib Turkey cooked to WELL DONE (180'F)
1. Switch Power ON.
2. Press MEAT + button and watch the dot icon until it stops beneath POULTRY.
3. There is no need to press the TASTE - button as only WELL DONE is option for poultry.
4. Plug the probe jack into the unit and insert the probe into the center of the turkey breast.
5. Put meat into oven. The probe wire will be held in place by the door.
6. Slide the VOICE, BEEP, OFF switch to VOICE. The ALERT icon will display next to the Alert Temperature. Slide the stand
out and snap into place and position outside the oven on nearby surface.
NOTE:
• The unit defaults to 4:00:00 (4 hours) cooking time for Poultry & PGM.
• As the turkey begins to cook the unit will monitor and display the internal cooking temperature, the cooking time and
the cooking time left.
• The unit is monitoring the temperature rise over time and will calculate an anticipated cooking time
remaining. It is the ONLY unit that anticipates when your food will reach the alert temperature.
• The bar graph will display a flashing PROCESSING and bar icons when the temperature is below 90°F. Once the
cooking temperature goes above 90°F the bar graph will display the cooking temperature as a percentage of alert
temperature in bar icons. As the bar icons remain on and fill from left to right the meat is getting closer to the alert
temperature.
• Also 30 minutes after the meat temperature reaches 90°F the unit will announce "Don't forget to baste" "Don't forget
to baste" and the BASTE icon will flash. The BASTE icon will flash until ALERT STOP button is pressed. Once
pressed the BASTE icon will go out. The unit will announce every 30 minutes the same baste announcement.
The unit will make the following announcements as the cooking time left reaches the following:
30 minutes remaining: "30 minutes until ready"
20 minutes remaining: "20 minutes until ready"
10 minutes remaining: "10 minutes until ready"
5 minutes remaining: "5 minutes until ready"
1 minute remaining: "1 minute until ready"
"10,9,8,7,6,5,4,3,2,1"
"Times Up" "Your food is done"
7. Press the ALERT STOP button to stop the announcement temporally or switch VOICE, BEEP, OFF switch to OFF to
shut it off permanently.
NOTE:
If the turkey is left cooking and the cooking temperature goes to 190°F (10°F higher than the alert temperature) then
the unit will activate the OVERCOOK ALERT and will beep 8 times per second and the OVERCOOK & ALERT icons
will flash on the display.
ntLKi-UL niw i&
• Do not immerse the probe in water while cleaning.
• Do not allow the probe or probe wire to come into contact with flames when using on grill. If cooking with a grill cover
closed, only use medium or low heat.
• Make sure the probe tip is inserted into the meat at least 1".
• If the temperature displayed seems to read too high or the temperature seems to increase too quickly check to make
sure the probe tip is not poking through the food to outside. Reposition the probe tip in the center of the thickest part of
food. Avoid touching bone or heavy fat areas.
• When the temperature of the probe is over 212°F the unit will display "HI".
• When the temperature of the probe is under 32°F or the probe jack is not connected properly the unit will display "LO"
(Picture 2)
CAUTIONS
• Always wear a heat resistant glove to touch the silicone probe sensor or wire during or just after cooking. Do not touch
with bare hands. (Picture 1)
• Keep the silicone probe sensor and wire away from children.
• Clean the silicone probe and dry thoroughly after each and every use. (Picture 4)
• Do not use the unit in the rain. It is not waterproof. (Picture 3)
• Do not expose the plug of the silicone probe or the plug in hole of the unit to water or any liquid.
This will result in a bad connection and faulty readings.
• Do not expose the unit to direct heat or surface. (Picture 3)
• Do not use silicone probe in microwave oven.
• Do not use the silicone probe sensor above 480°F. Doing so will deteriorate the wire.
CLEANING
• Always wear a heat resistant glove to touch the silicone probe sensor wire during or just after
cooking. Do not touch with bare hands.
• Keep the silicone probe sensor wire away from children.
• Wash the metal probe tip and silicon wrap wire with hot soapy water and dry thoroughly. Do not immerse the probe and
wire in water while cleaning.
• Wipe the electronic unit with damp cloth. Do not immerse in water.
STATEMENT OF FCC COMPLIANCE
This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference installation. This
equipment generates, uses, and can radiate radio frecquency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more if the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1 )This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference that
may cause undesired operation.
MAVERICK LIMITED 90 DAY WARRANTY
Maverick Industries Inc. warrants this product to be free of defects in parts, materials and workmanship for a period of 90
days, from date of purchase. Should any repairs or servicing under this warranty be required, contact Maverick Customer
Service by mail or phone for instructions on how to pack and ship the product to Maverick's National Service Center
located as follows:
Maverick Customer Service
94 Mayfield Ave.
Edison NJ 08837
Telephone: (732) 417-9666
Hours: Weekdays 8:30 AM- 4:30 PM
Do not send any parts or product to Maverick without calling and obtaining a Return Authorization Number and instructions.
This warranty is VOID if instructions for use are not followed; for accidental damage; for commercial use; for damage
incurred while in transit; or if the product has been tampered with.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
www.maverickhousewares.com
Printed in China

Advertisement

loading

This manual is also suitable for:

Et-84d