Table of Contents
Advertisement
E
User Manual
To install batteries:
•
Lift up the battery compartment cover as shown in
Figure
.
6A
•
Insert four fresh AA batteries in the compartment, placing
the batteries according to (+) and (–) on the inside of the
compartment.
•
Install the AA starter Battery pack as shown in Figure
Using the 12V Max DEWALT Rechargeable
Pack:
•
Install the 12V Max Battery pack as shown in
Figure
.
6B
WARNING:
Batteries can explode, or leak, and can cause
injury or fire. To reduce this risk:
•
Carefully follow all instructions and warnings on the battery
label and package and accompanying Battery Safety
Leaflet.
•
Always insert batteries correctly with regard to polarity
(+ and –), marked on the battery and the equipment.
•
Do not short battery terminals.
•
Do not charge disposable batteries.
•
Do not mix old and new batteries. Replace all of them at the
same time with new batteries of the same brand and type.
•
Remove dead batteries immediately and dispose of per
local codes.
•
Do not dispose of batteries in fire.
•
Keep batteries out of reach of children.
•
Remove batteries when the device is not in use
•
Use only the charger specified for your rechargeable
battery pack.
Personal Safety
•
Stay alert, watch what you are doing and use common
sense when operating a laser tool. Do not use tool while
tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating power tools may
result in serious personal injury.
8
•
Use personal protective equipment. Always wear eye
protection. Protective equipment such as dust mask, non-
skid safety shoes, hard hat, or hearing protection used for
appropriate conditions will reduce personal injuries.
Tool Use and Care
•
Do not use tool if switch does not turn it on or off. Any tool
that cannot be controlled with the switch is dangerous and
must be repaired.
•
Store idle laser tools out of the reach of children and do not
allow persons unfamiliar with the tool or these instructions to
operate the tool. Laser tools may be dangerous in the hands
of untrained users..
•
Use only accessories that are recommended by the
manufacturer for your model. Accessories that may be
.
6B
suitable for one tool, may become hazardous when used
on another tool.
Service
•
Tool service must be performed only by qualified repair
personnel. Service or maintenance performed by unqualified
personnel could result in a risk of injury.
•
When servicing a tool, use only identical replacement
parts. Follow instructions in the Maintenance section of
this manual. Use of unauthorized parts or failure to follow
Maintenance Instructions may create a risk of electric shock
or injury.
To locate your nearest DEWALT service center go to
http://www.DEWALT.com on the Internet.
Operating Tips
•
Use only new, high-quality, name brand AA batteries or
specified rechargeable DEWALT12V Max Li-Ion pack for
best results.
•
Ensure batteries are in good working condition. If the low
battery red indicator light is flashing, the batteries need
replacement.
•
To extend battery life, turn laser off when not working with or
marking the beam.
•
To ensure the accuracy of your work, check to make sure
your laser is calibrated often. See Field Calibration Check.
•
Before attempting to use the laser, make sure it is
positioned securely, on a smooth, flat surface.
•
Always mark the center of the beam created by the laser.
•
Extreme temperature changes may cause movement of
internal parts that can affect accuracy. Check your accuracy
often while working. See Field Calibration Check.
•
If the laser has been dropped, check to make sure your
laser is still calibrated. See Field Calibration Check.
Hide quick links:
Advertisement
Table of Contents
