Table of Contents
Advertisement
DAILY MAINTENANCE SCHEDULE
The following services should be performed daily or every 8 hours
of service, following the detailed maintenance instructions in the
operators manual.
______ Pump Drive Shaft: If required with drive shaft / coupler check for
______ Crankshaft adapter: If equipped with rubber grommets check
______ Non-Greaseless Pivot points: Inject grease until it appears at ends.
(Check Maintenance Section)
______ Hydraulic fittings: Check for leaks with paper or cardboard. Tighten
______ Knives: Inspect for missing or damaged knives, change (only
______ Belts: Check / Tighten / Replace belts as needed.
______ Main Frame / Deck: Unless otherwise specified retorque bolts
______ Hydraulic Fluid Level: Add, if required, per fluid recommendations.
______ Rear Flail Drive, Bearing
Flange and Shaft Couplers: Grease as instructed in the detailed
(if applicable)
______ Cutter Shaft and Ground Roller: Grease as instructed in the detailed
Service performed by:_______ Date:____/____/____ Hour
Meter:__________
** This page may be copied and used as part of the daily maintenance routine.
MAINTENANCE
end play and lubricate at zerks.
condition, replace if missing or damaged.
fittings or replace hoses immediately.
complete sets) as needed.
according to torque specifications in this
section.
Maintenance Section
JD 7X30 COUGAR ROT Maintenance Section 4-23
maintenance section.
maintenance section
Advertisement
Table of Contents
