Table of Contents
Advertisement
Procedure
Installation
1. Place the device and rail clip on the upper edge of the standard profile rail at the position
shown.
2. Push down the device.
3. Once the rail clip slides over the bottom edge of the DIN rail, push the device onto the rail.
The device engages with an audible click.
Removal
1. Push down the device until it is released by the rail clips.
2. Swing the device out of the standard profile rail.
3. Lift the device up and off.
7.4
Upright mounting
The fasteners and screws required are supplied with the device for the selected mounting
option (as specified in order number).
MCU 1720
Equipment Manual, 09/2019, A5E47437728B AB
Installation
7.4 Upright mounting
53
Advertisement
Table of Contents
