Rxcode; Txcode - Baofeng UV-3R Mark II Reference

RXCODE

Use the selective call to ignore unwanted calls from other
stations who are using the same frequency.
1) Press [ MENU/LOCK ] then rotate the [ DIAL ] knob to
MENU [1], RXCODE
2) Press the [ U/V ] key to enter the set mode.
3) Clockwise or counterclockwise rotation of [ DIAL ] knob to
select from OFF /67.0-754N,
Press [ MENU/LOCK ] again, to select the code (Positive or
negative), such as 023N---0231.
OFF —67.0 —I-023N —1.0231
NOTE: [CTCSS: 67Hz---254.1Hz (50 groups); DCS: 023N-
754N (104 groups)]
4) Press [ U/V ] key to save the setting.
5) Press [ MENU/LOCK ] or [ PTT ] to EXIT to normal
operation.

TXCODE

Set the transmitting signal according to the below instructions:
1) Press [ MENU/LOCK ] then rotate the [ DIAL ] knob to
MENU [2], TXCODE
2) Press the [ U/V ] key to enter the set mode.
3) Clockwise or counterclockwise rotation of [ DIAL ] knob to
select from OFF /67.0-754N,
Press [ MENU/LOCK ] again, to select the code (Positive or
negative), such as 023N---0231.
OFF —67.0 —I-023N —1.0231
NOTE: [CTCSS: 67Hz---254.1Hz (50 groups); DCS: 023N-
754N (104 groups)]
4) Press the [ U/V ] key to save the setting.
5) Press [ MENU/LOCK ] or [ PTT ] to EXIT to normal
operation.
4 June 20, 2012