Table of Contents
Advertisement
Battery Installation
Soother
Soother
• Locate the battery compartment door on the back of
the soother.
• Unfasten the screws in the battery compartment door with a
Phillips screwdriver.
• Open the battery compartment door and insert four size "C"
(LR14) alkaline batteries in the correct polarity as indicated in
the battery compartment.
• Close the battery compartment door and tighten the screws
with a Phillips screwdriver. Do not over-tighten.
Under normal use conditions, the batteries in the soother will
require replacement more often than the batteries in the remote.
When you notice that the sound slows down and is affected by
the light display or when the sound or lights become faint, it's
time to replace the batteries in the soother.
Remote
• Locate the battery compartment door on the back of
the remote.
• Unfasten the screw in the battery compartment door with a
Phillips screwdriver.
• Open the battery compartment door and insert two size "AA"
(LR6) alkaline batteries in the correct polarity as indicated in
the battery compartment.
• Close the battery compartment door and tighten the screw
with a Phillips screwdriver. Do not over-tighten.
Important Note: If the soother does not respond to use of the
remote it does not necessarily mean that the battery power in the
remote is low. Replace the batteries in the remote if the LED
signal indicator on the remote is dim when the button is pressed.
If the LED signal indicator does not light after installing new
batteries in the remote, check the orientation of the batteries in
the battery compartment to make
sure they are properly installed.
Battery Compartment
Remote
4
Advertisement
Table of Contents
