Black & Decker 598121-00 Instruction Manual page 11

598121-00 Pressure Wash Revised
TROUBLESHOOTING GUIDE - continued
Symptom Cause
Spray wand or Broken O-ring.
extension leaks.
Pump is excessively Pump is sucking air.
noisy.
Water leaks from Loose fittings.
pump. Water seals are damaged
or worn.
Oil seals are damaged or
Oil leak.
worn.
Motor buzzes but Supply voltage below
fails to run. minimum.
System has residual
pressure.
Voltage loss due to
extension cord.
Cleaner not used for long
periods.
11/24/03 2:01 PM Page 11
Solution
Contact B&D Customer Service
Representative at 1-800-544-6986.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until a
steady flow of water emerges from the
nozzle.
Check that all fittings are tight.
Contact B&D Customer Service
Representative at 1-800-544-6986.
Contact B&D Customer Service
Representative at 1-800-544-6986.
Verify that only the pressure washer is
running on this circuit.
Turn unit off, squeeze trigger on spray
wand to release pressure, then turn
unit on.
Do not use extension cord with this
unit - plug directly into outlet.
Contact B&D Customer Service
Representative at 1-800-544-6986.
11