Section 6: Care And Maintenance; Self-Cleaning The Oven - Thermador PG30 Care And Use Manual

Thermador gas ranges care and use manual
Hide thumbs Also See for PG30:
Table of Contents

Advertisement

Available languages

Available languages

SECTION SIX: CARE AND MAINTENANCE
LARGE GAS MAIN OVEN
The self-cleaning mode of your new range features
pyrolytic self-cleaning. When set to the CLEAN
mode, the oven reaches a high temperature,
°
approximately 830
F, that burns off the food soil.
When the oven is set for CLEAN, the cooktop burners
and electric griddle may be used. The secondary
oven (48" models), the griddle and/or the grill cannot
be used.
It is common to see smoke and/or flames during
the CLEAN cycle, depending on the content and
amount of soil remaining in the oven. If a flame
persists, turn off the oven and allow it to cool before
opening the door to wipe up the excessive food soil.
At the end of the CLEAN cycle, some gray ash or
burned residue may remain inside the oven. This is
a mineral deposit that does not burn or melt. The
amount of ash depends on how heavily soiled the
oven was before it was cleaned. It is easily removed,
when the oven is cold, using a damp paper towel,
sponge, or cloth.
Wipe off any smoke residue that remains on the front
®
frame with Formula 409
use a mild liquid cleanser. The amount of smoke
stain is directly related to the amount of food soil left
in the oven at the time of self-cleaning. Clean the oven
often.
BEFORE SELF CLEANING THE OVEN
Wipe out puddles of grease and any loose soil that can
be easily removed.
Remove any soil that is outside the door seal area.
This appliance is designed to clean the oven interior
and that portion of the door that is inside the oven. The
outer edges of the door and the oven cavity are not in
the cleaning zone. Wipe this area clean BEFORE
SETTING THE OVEN TO SELF-CLEAN.
Remove all utensils.
Remove Racks.
Clean the oven front frame and outer door
edges. Wipe up large spillovers and
grease.

Self-Cleaning the Oven

®
or Fantastik
. If stain remains,
Be sure the light bulbs and glass covers
are in place.
Turn on the ventilator hood above the
range and leave it on until the oven has
completed the self-clean cycle.
IMPORTANT: For the first
Self-Cleaning cycle, remove
small animals and birds from
the kitchen and surrounding
areas.
Open
window
ventilation.
If another clean cycle is initiated at the end of a clean
cycle and the temperature of the oven is still above
°
500
, the LED will start blinking to indicate the range
has not completely cooled down after the first cycle.
The oven cannot be used until the oven temperature
°
drops below 500
and the door is unlocked.
LOCK
When the CLEAN cycle starts, the LOCK light turns
on, and the automatic door lock cycle begins. The
temperature gauge begins to move to CLEAN five
minutes after the clean mode is initiated. Check the
door when the LOCK light comes on to confirm that
it is locked. You can stop the clean cycle by selecting
the OFF position. The lock light will turn off only after
the oven has cooled below 500
door lock has completed its cycle to the open position.
Make certain that the oven door is locked at the
beginning of the self-cleaning cycle.
30
a
nearby
for
additional
°
F, and the automatic

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents