Basic Functions; Radio - Philips AZ1200 Manual

BASIC FUNCTIONS

Switching on and off
Set the POWER slider to the desired sound source:
CD, TUNER, or TAPE.
The set is switched off when the POWER slider is in position
O O F F F F /TAPE and the keys of the tape deck are released.
Note: If you run the set on batteries, always be sure to switch the
set off after use. This will avoid unnecessary power
consumption.
Adjusting volume and sound
Adjust the volume using the VOLUME control.
™ Display indication: Volume level from 0 to 32 (AZ 1205 only).
Increase and decrease the bass level by pressing DBB.
The bass level can also be emphasised if you place the set
againsta wall or shelf. Do not cover any vents and leave sufficient
room around the unit for ventilation.
Radio – tuning to radio stations
1 Set the POWER slider to TUNER.
2 Select the wave band by using the BAND selector.
3 Tune to the desired radio station by using the TUNING knob.
Improving RADIO reception
For FM stations, pull out the telescopic antenna. To improve the
signal, incline and turn the antenna. Reduce its length if the signal
is too strong (very close to a transmitter).
For MW stations, direct the built-in antenna by turning the whole
set. The telescopic antenna is not needed.
8

RADIO

AZ 1200 AZ 1205
AZ 1201