Advertisement
PART 14-1-
FORD STARTING SYSTEM
14-3
STARTER WILL NOT CRANK ENGINE-ROW lltAP (SEE NOTE NO. 1)
I
CHECK THE BATTERY AND STARTER CABLES FOR GOOD ELECTRICAL CONTACT
.
*
LOOK FOR BROKEN OR CORRODED CONNECTIONS
.
IN PARTICULAR ASSURE GOOD
GROUND CONNECTIONS
.
CLEAN AND TIGHTEN THE CABLE CONNECTIONS AS NECESSARY
.
CHECK THE BATTERY SPECIFIC GRAVITY
.
BATTERY SPECIFIC GRAVITY OK
BATTERY SPECIFIC GRAVITY LOW
PERFORM THE BATTERY
TESTS.
CHARGE OR REPLACE THE
*BATTERY AS NECESSARY
.
CHECK THE BATTERY AND STARTER
CABLES AND STARTER RELAY FOR EXCE"SSIVE RESISTANCE
.
CHECK THE STARTER RELAY·OPERATE THE STARTER (IGNITION) SWITCH
.
*
BY-PASS THE RELAY WITH A
HEAVY JUMPER CABLE .SEE
NOTE NO
.
2.
I
RELAY DOES NOT CLICK
*
BY-PASS THE IGNITION
SWITCH,
NEUTRAL STARTS
TCH AND
WI
WIRING
.
SEE NOTE NO.3
.
ENGINE CRANKS
I I
ENGINE WILL NOT CRANK
J
~
* REPLACE RELAY
I
STARTER ENGAGEMENT
WEAK OR NO
ENGAGEMENT
.
I
I
* REMOVE AND TEST THE
STARTER. REPAIR
AS
REQUIRED.
I
STARTER ENGAGEMENT
FIRM. ENGINE
LOCKED UP
.
I
I
* REFER TO GROUP 8
FIG. 2-Starter Will Not Crank Engine-Road Map
STARTER SPINS,BUT WILL NOT CRANK ENGINE
* REMOVE THE STARTING MOTOR AND DRIVE
.
CHECK AND
CLEAN THE STARTER DRIVE AS REQUIRED. CHECK FOR
DAMAGED FLYWHEEL RING GEAR TEETH
.
WHEN INSTALLING
THE STARTER, PROPERLY ALIGN IT TO THE FLYWHEEL
HOUSING
.
ENGINE WILL NOT CRANK
* CHECK THE WIRING TO THE IGNITION
SWITCH, NEUTRAL START SWITCH
AND WIRING TO STARTER
RELAY·.
SEE
NOTE
NO. 4.
*
BY·PASS RELAY WITH A
HEAVY JUMPER CABLE.
SEE NOTE NO.
2.
ENGINE WILL NOT CRANK
STARTER ENGAGEMENT
WEAK OR NO
ENGAGEMENT.
*REPLACE RELAY
STARTER ENGAGEMENT
FIRM, ENGINE
LOCKED UP
* REFER TO GROUP 8
J 1316-A
Advertisement
