DeLonghi Dinamica ECAM35020W Manual page 17

PROBLEM
The coffee is weak or not creamy enough. The coffee is ground too coarsely.
The coffee is delivered too slowly or a
drop at a time.
The machine will not make coffee
The infuser (A8) cannot be extracted
At the end of descaling, the machine re-
quests a third rinse
The frothed milk has large bubbles
The milk is not frothed
Steam delivery stops
The machine does not turn on
Coffee does not come out of one or both
of the coffee spouts
POSSIBLE CAUSE
The coffee is ground too finely.
The machine has detected impurities in
its internal circuits, the
flashes
The machine has not been turned off
correctly
During the two rinse cycles, the water
tank has not been filled to the MAX level.
The milk is not cold enough or is not
semi-skimmed
The frother (A22) and steam/hot water
connection nozzle (A21) are dirty
A safety device stops steam delivery
The machine is not plugged into the
mains socket
The main switch (A6) is not turned on
The coffee spouts (A19) are blocked
22
REMEDY
Turn the grinding adjustment dial (A5)
one click anticlockwise towards 1 while
the coffee grinder is in operation (fig. 8).
Continue one click at a time until coffee
delivery is satisfactory. The effect is only
visible after delivering 2 coffees (see sec-
tion "13.1 Adjusting the coffee grinder").
Turn the grinding adjustment dial (A5)
one click clockwise towards 7 while the
coffee grinder is in operation (fig. 8).
Continue one click at a time until coffee
delivery is satisfactory. The effect is only
visible after delivering 2 coffees (see sec-
tion "13.1 Adjusting the coffee grinder").
Wait for the machine to be ready for use
light (B1) again and reselect the required beverage.
Contact Customer Services if the problem
persists.
Turn the machine off by pressing the
button (A23) (see section "5. Turning the
machine off").
Follow the instructions displayed by the
machine, but first empty the drip tray
(A15) to avoid the water overflowing.
You should ideally use skimmed or semi-
skimmed milk at refrigerator tempera-
ture (about 5°C). If the result is not as you
wished, try changing brand of milk.
Clean as described in section "15.1 Clean-
ing the frother after use".
Wait a few minutes and then enable the
steam function again.
Plug into the mains socket (fig. 1).
Press the main switch (fig. 1).
Clean as described in section "17.7 Clean-
ing the coffee spouts".