Table of Contents
Advertisement
Main Icons
Remocon
Safety Lock
Port Selection
1. Use the main icons to switch into each screen.
2. Allows you to enable or disable the remote control signal receiving function of the monitor unit.
3. Set the Safety Lock function.
When setting the Lock function, you can only operate power and lock buttons on the remote control and set.
4. The setting for the PC Serial Port can change. The original value is COM1.
5. Click Select all or Clear to select or clear all monitors.
6. Use Grid to view brief information on selected monitor.
7. Select a monitor from monitor Selection.
8. Use Control Tools to control monitors.
<Note> The remote control Enable/Disable function operates whether or not the power is On/Off, and this
applies to all monitors connected to the MDC. However, regardless of the status at the time the MDC is
shut down, the remote control signal receiving function of all monitors is initialized to Enable when the
MDC is closed.
Port Selection
Select Button
Info Grid
Monitor Selection
Control Tools
2
Advertisement
Table of Contents
