Drum/Caster Foot Assembly
If any parts are missing or damaged
contact Customer Service.
Do not assemble until you have all the
parts.
1. Insert the front and rear caster feet into
the bottom of the drum, as shown. Light
taps with a mallet or hammer may be
needed to fully seat both caster feet.
2. Install four screws into matching holes
on both front and rear caster feet,
securing them to the bottom of the
drum. Tighten screws until just snug.
Do not over tighten as this may tend to
deform the caster feet.
3. Insert the caster stem into each of the
caster feet, as shown.
4. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will be able to hear the
ball snap into the socket and the caster
will swivel easily when positioning is
correct.
Drum
Front
Caster
Foot
Drain
Screws (4)
Socket
5 5
Rear
Caster
Foot
Drain
Rear Caster
Foot
Caster Stem
Caster Ball
Front
Caster
Foot