Advertisement
Note: You must install the appropriate
lens on the box camera before this step.
Please choose a lens with specifications
that are suitable for the application.
3.
Install the camera and base plate assembly in
the housing. Tighten the four screws to keep
the camera assembly firmly in place.
4.
Attach the housing to the TVC-M2-WM wall
mount bracket by using the two B screws.
5.
Route the cables into the housing through the
cable gland.
Note: Please ensure that the power
supply is OFF during installation.
6.
Connect the power supply (purchased
separately) cable to the 24 VAC input
terminals on the terminal panel.
P/N 1073110-EN • REV C • ISS 02FEB17
Terminals:
24 VAC output: Connect the camera
24 VAC input.
12 VDC: Connect the camera 12 VDC
power input. The positive/ negative
terminals should be distinguished.
RS-485 Port: Reserved for wiper control
(the wiper feature is not supported in this
model)
Note: 24 VAC/4 A UL listed Class 2 or
CE certified power supply is required
(purchased separately) for the device to
function properly.
The fan and heater are prewired at the
factory.
7.
Connect the power and video coax cable
and/or Ethernet cable to the box camera.
Power a 12 VDC camera:
Heater
1.
Black 12 VDC-
Fan
24 VAC input
2.
Red 12 VDC+
3 / 4
Advertisement
