NEED HELP? LEAVE THE TECH TO US LIVE 24/7 TABLE OF CONTENTS TECHNICAL SUPPORT 1.877.877.2269 1. OVERVIEW ...................................... 3 1.1 Introduction .......................................3 1.2 Safety.........................................3 1.3 What’s Included ......................................3 1.4 Rackmount Tray Illustrated ..................................3 2. INSTALLATION INSTRUCTIONS ..............................4 2.1 Installing the Rackmount Tray .................................4 2.2 Installing the Transmitter or Receiver ..............................6 APPENDIX: DISCLAIMER/TRADEMARKS ............................
TECHNICAL SUPPORT 1.877.877.2269 1.1 INTRODUCTION Use the Emerald 4K Rackmount Tray (EMD4000-RMK1) to mount up to (2) Emerald 4K Transmitter and/or Receiver (EMD4000-T/R) units in a 2-/4-post 19" rack or cabinet. 1.2 SAFETY WARNING! Rack loading — Overloading or uneven loading of racks may result in shelf or rack failure, possibly damaging the equipment and causing personal injury.
NEED HELP? LEAVE THE TECH TO US LIVE 24/7 CHAPTER 2: INSTALLATION INSTRUCTIONS TECHNICAL SUPPORT 1.877.877.2269 2.1 INSTALLING THE RACKMOUNT TRAY Follow the installation instructions listed below in numerical order. STEP 1: Remove the rackmount tray from packaging and place it on a secure surface. STEP 2: Install the cage nuts (supplied) on both sides of the rack.
Page 5
NEED HELP? LEAVE THE TECH TO US LIVE 24/7 CHAPTER 2: INSTALLATION INSTRUCTIONS TECHNICAL SUPPORT 1.877.877.2269 STEP 4: Tighten all mounting screws to secure the tray in the rack. See Figure 2-3. FIGURE 2-3. TIGHTEN THE MOUNTING SCREWS STEP 5A: Install the locking bracket on the tray using the thumbscrew provided and leave in the “open” position. See Figure 2-4. FIGURE 2-4.
NEED HELP? LEAVE THE TECH TO US LIVE 24/7 CHAPTER 2: INSTALLATION INSTRUCTIONS TECHNICAL SUPPORT 1.877.877.2269 2.2 INSTALLING THE TRANSMITTER OR RECEIVER Install one or two Transmitter or Receiver units in the rackmounted dual tray. STEP 1: Install one Transmitter or Receiver into either slot from the front. The transmitter or receiver is fully inserted when it hits the stop feature of the dual tray.
A.1 DISCLAIMER Black Box Corporation shall not be liable for damages of any kind, including, but not limited to, punitive, consequential or cost of cover damages, resulting from any errors in the product information or specifications set forth in this document and Black Box Corporation may revise this document at any time without notice.