Table of Contents
Advertisement
Configuration Pre-check
Before making connections, read the following configuration notes. Make sure all internal controls are properly set for your
intended usage.
To access the internal controls, do the following:
Remove the four (4) screws on the front panel that secure the intercom station faceplate to the mounting box.
1.
Pull the faceplate out for all versions (except the RM version).
2.
To access the internal controls for the RM version, do the following:
Remove the 10 screws securing the cover on the box.
1.
Lift the cover off.
2.
DIP Switches
DIP Switch descriptions and factory default settings
TABLE 1.
Switch
Number
1
Mic Kill Receive
2
Call Signal Method
3
Incoming Call Beep
4
Microphone Type
Speaker Beep for Incoming
5
Call
6
Not Used
7
Not Used
8
Not Used
Description
Closed: Disabled, No Mic Kill
Open: Enabled, Mic Kill Active
Closed: DC (SW1 set to UNBAL)
Open: Audiocom (SW1 set to BAL)
Closed: Disabled
Open: Enabled
Closed: Unbalanced
Open: Balanced
Closed: Enabled (DIP switch 3 must be set to Open)
Open: Disabled
Not Defined
Not Defined
Not Defined
Settings
Open = OFF; Closed = ON
CHAPTER 2
Installation
Default
Settings
Open
Open
Open
Open
Open
Open
Open
Open
7
Advertisement
Table of Contents
