Preparation Instructions; Starting And Stopping - Electrolux Flymo Series Instruction Manual

Fitting the Cable Holder to Your
Hedgetrimmer (A) and (B)
1. Insert T-shaped hooks of cable holder into T-
shaped holes on the underside of your
Hedgetrimmer.
(See Fig. A)
2. Secure by pulling the cable holder, in the
direction shown, away from the
Hedgetrimmer, blades until it locks into posi-
tion.
(See Fig. B)
Before starting your Hedgetrimmer.
1. Form a loop in mains cable and push the loop
through the hole in the cable holder as illus-
trated in Fig. C.
2. To secure, position the loop around the hook
as illustrated in Fig. D.
3. Connect to mains and switch on
4. Remove blade cover/storage holder as illus-
trated in Fig. E.
To start your Hedgetrimmer (F)
1. There are two switch levers fitted to your
Hedgetrimmer.
2. Both switch levers need to be held in the
operating position (See Fig F) for the product
to start.
To stop your Hedgetrimmer (G)
• Move Hedgetrimmer away from cutting area
before stopping.
1. To stop, release one of the switch levers.

Preparation Instructions

A
B

Starting and Stopping

C
E
F
G
4
D