Assembly & Set-Up - Troy-Bilt TB 672 Operator's Manual

Assembly & Set-Up
Contents of Carton
• Jet Sweep Blower (1)
• Safety Glasses (1)
• Oil ( 1 bottle)
• Star Knob (2)
NOTE: All references to the left or right side of the
jet sweep blower are from the operator's position.
Any exceptions will be noted.
Assembly
Attaching the Upper Handle
1. Remove the carriage screws (a) and star
knobs (b) from the carton. See Figure 3-1.
Figure 3-1
• Upper Handle (1)
• 90° Discharge Chute Attachment (1)
• Product Registration Sheet (1)
• Carriage Screw (2)
2. Place the upper handle over the lower
handle, aligning the upper holes/metal
tabs in the upper handle with the upper
holes/lower holes in the lower handle.
Secure the upper handle to the lower
handle with the carriage screws (a) and
star knobs (b). See Figure 3-2.
a
b
Figure 3-2
• Jet Sweep Blower Operator's Manual (1)
• Jet Sweep Blower Fast Start Guide (1)
• Engine Operator's Manual (1)
Set-Up
Adding Oil
Refer to the Engine Operator's Manual for
information on adding and checking oil.
CAUTION:
Always check the
engine oil level before each use as
instructed in the Engine Operator's
Manual. Add oil as necessary.
Failure to do so may result in
serious damage to your engine.
Adding Fuel
Refer to the Engine Operator's Manual for
information on adding fuel.
WARNING!
Use extreme care
when handling gasoline. Gasoline
is extremely flammable and the
vapors are explosive. Never fuel
the machine indoors or while the
engine is hot or running.
Extinguish cigarettes, cigars, pipes
and other sources of ignition.
3
5