Advertisement
Pull the bracket fixing part of the wall mount as far forwards as possible. Then two persons should hold the PDP and hang the
PDP onto the specified part of the wall mount.
Tie the power cord and other cables with the supplied wire tie as shown by the figure
and check if the wires are not disconnected or moved out of position.
※ If you insert the cable, pull the angle adjuster as far
forwards as possible, and then arrange the cables
using the specified hole of the angel adjuster, the wall
mount will not interfere with the cables when it swivels
Check the operation 2 or 3 times and if there is no
problem, fix the wall molding.
Adjusting the Wall Mount
※ This wall mount has adopted the Smooth Moving Mechanism for more comfortable use. Users can
adjust the wall mount very smoothly.
W
a
r
n
i
n
g
W
a
r
n
i
n
g
※
※
After completely fixing the PDP main body onto the wall
mount, fasten the safety pins at the top parts of both
sides of the wall mount so that the PDP main body and
the wall mount are not separated.
Take care when adjusting the wall mount, as moving the wall mount
with excessive force may cause the wall mount to collide with the wall
and result in damage to the wall mount and the wall.
When swiveling the wall mount, hold both sides of the product with
your hands and when tilting the wall mount, hold the top center of the
product for a smooth operation.
※ You can swivel the wall mount up to 10º in both direction.
The angle of the angle adjuster may differ depending on the model.
Advertisement
