Thrive Energy Technologies ACCENDO Faqs On Maintenance And Repairs

FAQs on Maintenance and Repairs of ACCENDO Solar LED Home Light
# FAQ
1 The lamp is OFF and unable
to switch ON
2
The lamp is not charging
although the solar panel is
connected to the light
What needs to be done
3
when the ACCENDO has a
less back up or runtime?
When the light lasts for
few hours?
Solution
a. Press the ON/OFF push button and check lighting level in all the three
lighting modes.
b. Check the Low battery indication. If the battery indication is showing Red
with a Continous blink, the light needs to be charged immediately with the
Solar panel or mains charger.
a. Check the direction, angle of installation and cable of solar panel to ensure
perfect charging of the ACCENDO lamp. Please refer to user manual for the
solar panel installation instructions.
b. Observe the charging indication on the ACCENDO lamp. The lamp should
show RED while charging the battery and GREEN after full charge.
c. Measure the internal battery voltage using a multimeter. If the battery is
Charged the voltage should be 6.4V (DC) and when the battery is discharged
the voltage should not be less than 5.4V (DC).
a. The back up or run time is also reduced if the battery is not properly charged
using a charging source.
b. If the back up or runtime is low it means that the battery lifetime is about to
expire. Please change the battery with the new one.
Procedure